Nuova Simonelli AURELIA II Manuel D'instructions page 70

Manually:
After entering in the program of the first
group, press the keys of the first
group, keys of the first and second group
show the temperature starting from a mini-
mum value of 50°C.
At every key has an value:
Keys 1° GROUP
1 °C
2 °C
4 °C
8 °C
Sum together the value associated to the
relevant lit key to a minimum value of 50°C
to obtain the temperature setting.
If the key is lit, it is necessary to add the
reference value, while it is not required if the
key is not lit.
By pressing again the
is planned and the machine came back to
the general programming.
This way of setting doesn't use the delivery
of steam.
To escape from the program and save the
setting, press the continuos
first group.
72
Technician:
In this steam temperature setting is possible
to plan the offset value, from -15°C to
+15°C, to obtain the correct temperature
value.
By pressing the
showed the offset value setted:
the way to show is the same of the way to
show the final steam temperature.
2° GROUP
The keys of the first group show a value from
10 °C
0 to 15°C, the
show the offset sign:
it is switched on the value is positive, if the
20 °C
key is switched off is negative.
Keys
-
-
key the value
By releasing the
you memorize the value and came back to
the steam temperature setting.
key of the
key of the first group, is
key of the second group
1° GROUP 2° GROUP
1 °C + o - °C
2 °C -
4 °C -
8 °C -
key of the first group,
STANDARD DOSE PROGRAMMING
Setting predetermined values for the four
doses of the first delivery unit is not possible.
To do so, you must:
Press the first unit continuous delivery
key and keep pressing it for at least 8 sec-
onds, until the flashing delivery keys of the
first unit turn off.
The standard doses are illustrated in the fol-
lowing table:
40 cc 60 cc 50 cc 85 cc
NOTE: A time setting of 0 seconds for the
steam will set it to operate continuously.
DOSE COPYING:
This procedure must be carried out for each unit
individually by pressing the
delivery key of the unit you desire to copy the
doses onto and keep pressing it for at least 8
seconds, until the flashing delivery keys turn off.
AUTOMATIC CLEANING CYCLE
To enter the automatic washing status, it is
necessary to switch the machine off and
then on again, while holding down the
hot water key and the one long coffee,
st
1 unit during the initial Lamp test. At the
end of the Lamp-test, the
and the one long coffee on all units will
begin to flash on all units.
9 sec. 0 sec.
continuous
hot water