Nuova Simonelli AURELIA II Manuel D'instructions page 61

followed by the temperature set previously
by the manufacturer.
Press the keys to vary the
temperature of the beverage you want to
heat. When the desired temperature has
been reached, the steam delivery will auto-
matically stop.
In the standard version (without temperature
probe), on pressing the
will read:
PROGRAM. DOSES
STEA.SEC.
followed by the amount already set by the
manufacturers.
Press the keys to vary the
steam delivery time.
If a new sampling is desired press the
button again.
Delivery starts. When the desired dose has
been reached press the button again
The display will show the new value set
which can still be changed by pressing the
.
Press the key or go on to a further
selection to terminate the operation.
Press the key to cancel program-
ming.
The button will turn off.
TRANSFERRING DOSES
When the display reads:
PROGRAM DOSES
transferring the set dose to other units is
the display
possible by pressing the
The display will read:
DOSES TRANSFER
SELECT GROUPS
at this point, the continuous coffee keys
of the second, third and fourth groups
will flash as shown in Fig. 27.
Selecting the continuous key
will stop flashing and remain lit) will transfer
the values programmed for the first group to
the other groups, one at a time.
.
Press the
At this point the display will read:
PROGRAM DOSES
Press the
without confirmation.
SELECT
key
(the key
Fig. 27
key to confirm.
SELECT
or the key to exit
STANDARD DOSES
When the display reads:
DOSES TRANSFER
SELECT GROUPS
we mean to recall the standard dose values.
Press the key.
The display will read:
DEFAULT SETING
SELECT GROUPS
At this point, the continuous coffee keys
will begin to flash.
Select one or more continue keys (the key
or keys selected will remain lit up).
The key or keys will recall the selected unit's
standard doses.
Press the key to confirm.
The display will read:
PROGRAM DOSES
SELECT
Press the or the
without confirmation.
NOTE: all the selections can be programmed
for a maximum of two minutes; after
that time a flashing message will
appear on the display saying:
ERROR
key to exit
63