5 .6
Connecting control voltage cables
• Mount the control panel at the helm position. There must be 150
mm of free space behind the panel.
• Connect the panel as shown in the dia-
gram.
See diagrams on pages 165 - 171 if sev-
eral panels have to be connected.
• Connect the CAN-bus supply to a 12-Volt
power supply.
n
ote
The CAN bus is a chain to which the bow
thruster and the panels are connected.
At one end of the chain, the power supply
(5) must be connected and the terminator
(8) must be connected at the other end!
32
020811.01
Terminator
+
12 V
Control voltage fuse
8
+
12 V
5
vetus® Installation instructions BOW PRO Series Thrusters: BOWA0761
- BPPJA
Control panel
Connection box thruster
Connection cable
Connection cable
CAN-bus supply
M
+
12 V
5
- BPPPA
8
M