Endress+Hauser FlexView FMA90 Manuel De Mise En Service page 38

Intégration système
38
8.3 Commandes HART prises en charge (esclave)
L' e sclave HART intégré de l' a ppareil prend en charge les commandes suivantes :
N° commande Description
Universal commands
0, Cmd0 Read unique identifier
1, Cmd001 Read primary variable
2, Cmd002 Read loop current and percent of range
3, Cmd003 Read dynamic variables and loop current
6, Cmd006 Write polling address
7, Cmd007 Read loop configuration
8, Cmd008 Read dynamic variable classifications
9, Cmd009 Read device variables with status
11, Cmd011 Read unique identifier associated with TAG
12, Cmd012 Read message
13, Cmd013 Read TAG, descriptor, date
14, Cmd014 Read primary variable transducer information
15, Cmd015 Read device information
16, Cmd016 Read final assembly number
17, Cmd017 Write message
18, Cmd018 Write TAG, descriptor, date
19, Cmd019 Write final assembly number
20, Cmd020 Read long TAG (32-byte TAG)
21, Cmd021 Read unique identifier associated with long TAG
22, Cmd022 Write long TAG (32-byte TAG)
38, Cmd038 Reset configuration changed flag
48, Cmd048 Read additional device status
Common practice commands
33, Cmd033 Read device variables
35, Cmd035 Write primary variable range values
40, Cmd040 Enter/Exit fixed current mode
44, Cmd044 Write primary variable units
45, Cmd045 Trim loop current zero
46, Cmd046 Trim loop current gain
50, Cmd050 Read dynamic variable assignments
51, Cmd051 Write dynamic variable assignments
54, Cmd054 Read device variable information
59, Cmd059 Write number of response preambles
60, Cmd060 Read analog channel and percent of range
63, Cmd063 Read analog channel information
72, Cmd072 Squawk
95, Cmd095 Read Device Communication Statistics
100, Cmd100 Write Primary Variable Alarm Code
FlexView FMA90
Endress+Hauser