Leds On Battery; Led On Charger; Assembling The Trimmer - Stihl Fsa 70.0 R Notice D'emploi

7 Assembling the Trimmer

6.3 Displaying the state of charge
1
► Depress the pushbutton (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.1.
Malfunction in trimmer or battery.
6.5

LED on Charger

The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7 Assembling the Trimmer
7.1 Attaching the deflector
► Switch off the brushcutter and remove the bat‐
tery.
1
2
3
The line limiting blade (2) has already been
installed in the deflector (1) and must not be
removed.
0458-063-9601-A
80-100%
60-80%
40-60%
20-40%
0-20%
4
► Fit the deflector (1) on the housing (3) and line
up the holes.
► Insert screws (4) and tighten them.
The deflector (1) must not be removed.
7.2 Attaching the loop handle
► Switch off the brushcutter and remove the bat‐
tery.
1
9
4
8
7
► Insert the pin (8) into the opening in the quick
release clamp (5).
Align the pin (8) so that the notch of the pin is
at the bottom.
► Place the clamp (3) in the loop handle so that
the holes are aligned.
► Place the loop handle (2) with clamp (3) on the
shaft (9).
► Insert the long screw (7) through the holes in
the pin and quick release clamp (5).
► Press the clamp (4) against the shaft so that
the holes are aligned.
► Insert the short screw (6) through the holes.
► Insert the long screw (7) through the holes.
► Screw on the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) is properly adjusted if it can
no longer be moved.
► If the loop handle (2) can be moved:
► Open the quick release clamp (5).
► Tighten the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
► If the quick release clamp (5) cannot be
closed:
► Open the quick release clamp (5).
► Loosen the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
English
2
3
5
6
37