VEVOR RBM50 Mode D'emploi page 5

22. Stop machine before servicing and when changing accessories such as
rollers, etc
23. General Electrical Cautions :This machine should be grounded in
accordance with the National Electrical Code and local codes and ordinances.
This work should be done by a qualified electrician. The machine should be
grounded to protect the user from electrical shock.
24. LABOUR PROTECTION RULES for Round bending machine
—Take the machine from the mains for any repair of intervention.
—It is forbidden to intervene to the gears during operation. They are protected by
guards.
—Check the fasting of the bending rollers on the shafts before starting the
machine.
—Do not use pinched or cracked bending rollers.
Note: The warning and instructions contained in this instruction manual cannot
cover all possible conditions and situations that may occur when using this product.
It must be understood that common sense and caution are factors, which cannot
be built into this product. These factors must be supplied by the person whom
operating this piece of equipment.
MODEL
Max capacity (mm)
Diameter of roller shaft
Motor Power
SPECIFICATIONS
Pipe steel
Square tube steel
Round steel
Flat steel
- 4 -
RBM50
φ70x2
35X35
φ35
100X15
φ50mm
2.2kW