VEVOR RBM50 Mode D'emploi page 4

9. Do not overreach. Keep proper footing and balance at all times. Do not reach
over or across running machine.
10. Maintain tools with care. Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and changing accessories. The
handles must be kept clean, dry, and free from oil and grease at all times.
11. Stay alert. Watch what you are doing; use common sense. Do not operate
any tool when you are tried.
12. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of moving parts;
any broken parts or mounting fixtures; and any other condition that may affect
proper operation. Any part that is damaged should be properly repaired or
replaced by a qualified technician.
13. Guard against electric shock. Prevent body contact with grounded surfaces
such as pipes, radiators, ranges, and refrigerator enclosures.
14. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are available
from the distributor.
15. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment of reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
16. Don't leave machine until it comes to a complete stop.
17. Make sure machine is disconnected from power supply while making
maintenance, adjustment or repair
18. Always keep hands and fingers away from the rollers.
19. Avoid accidental starting. Make sure switch is in "OFF" position before
plugging in power cord
20. Ground all machines. Always make sure your machine is well connected to
the earth. It may reduce electric shock hazards.
21. Don't use in dangerous environment . Don't use power machine in damp or
wet locations, or expose them to rain. Keep work area well lighted
- 3 -