Step 9, Install Filters; Step 10, Finalize Installation - GE Monogram ZV750 Instructions D'installation

9 INSTALL FILTERS
• There are two channels inside the back and front of the
hood. These channels will hold the charcoal filters and
stainless steel grease filters in place.
Install charcoal filters
• Remove protective film on the charcoal filters.
• Tip charcoal filters into the upper (top) channels at the
rear of the opening. Grasp the filter tab, lift and pull
forward until it rests in the front upper channel.
• Install all 3 charcoal filters.
Install grease filters
• Remove protective film from grease filters.
• Tip the grease filter into the lower channel at the rear of
the opening. Push back, lift and pull the knob forward until
the filter rests on the channel.
• Install all 3 grease filters.
• Turn power on. If the filter light on the control panel glows,
adjust the right-side filter in the channel to engage the
switch arm.
10 FINALIZE INSTALLATION
• Remove protective film covering the control panel
on the front face of the hood and any remaining
packaging materials.
• Make sure the filters are seated properly when
installed and the filter light is not on.
Installation Instructions
INSTALLATION – RECIRCULATING
Upper charcoal
filter channel
Lower charcoal
filter channel
Upper charcoal
lter channel
Lower
filter slots
• Be sure fan and lights operate correctly. Refer to
the Owner's Manual for operating instructions and
Problem Solver.
18
Grasp tab,
lift and pull forward