Features - Ridgid Rdtr7000 Manuel De L'opérateur

FEATURES

PRODUCT SPECIFICATIONS
ENGINE
Engine Type ....................................................... Honda GX390
Bore x Stroke ..................................................88 mm x 64 mm
Cooling System ....................................................... Forced Air
Compression Ratio ........................................................... 8:0:1
Starting System ..............................................Recoil & Electric
Ignition System ................................................................ T.M.I.
Spark Plug ..........................................................NGK BPR6ES
Engine Lubricant Volume................................................1.1 qt.
Fuel Volume ..................................................................... 8 gal.
KNOW yOUR GENERATOR
See Figure 3.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as well
as a knowledge of the project you are attempting. Before use
of this product, familiarize yourself with all operating features
and safety rules.
AC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator against
electrical overload. The circuit breaker may be reset by pressing
the circuit breaker reset button.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
CHOKE LEVER
The choke lever is used when starting the engine.
CIRCUIT PROTECTOR
Protects the battery charge circuit from short circuit.
CONTROL PANEL CORD
The 25-ft. control panel cord (Model No. RDEC25) has a
120/240 Volt, 20 Amp twist lock plug and a 12 Volt DC engine
control connector on each end. When using this cord with
the removable control panel, appropriate equipment can be
powered through the 2 x 120 Volt duplex GFCI outlets on the
removable control panel.
FUEL TANK WITH FUEL GAUGE
The fuel tank has a capacity of 8 gallons.
FUEL VALVE
The flow of fuel through the generator is controlled by the posi-
tion of the fuel valve.
GenSmart MONITORING SySTEM
™
The GenSmart monitoring system tracks usage and load and
alerts the operator when periodic engine maintenance is rec-
ommended.
GENERATOR
Rated Voltage ......................................................... 120V/240V
Rated Amps ...................................................... 58.3 A / 29.2 A
Rated Output ...............................................................7,000 W
Maximum Output.........................................................8,750 W
Rated Frequency .............................................................60 Hz
DIMENSIONS
Length ............................................................................ 31 in.
Width ............................................................................... 30 in.
Height .............................................................................. 27 in.
Weight ......................................................................... 256 lbs.
NOTE: GenSmart
for the 120 Volt, 20 Amp GFCI outlets on the removable
control panel. It does not measure load on the 240 Volt,
30 Amp outlet.
GROUND TERMINAL
The ground terminal is used to assist in properly grounding the
generator to help protect against electrical shock. Consult with
a local electrician for grounding requirements in your area.
OFF SWITCH
To turn the engine off, press and hold the OFF switch until the
engine stops or turn the ignition switch to the OFF position.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the gen-
erator when necessary.
OIL DRAINAGE BOLT
When changing the engine lubricant, the oil drainage bolt is
loosened to allow old engine lubricant to be drained.
ENGINE SWITCH WITH SWITCH KEy
The engine switch and switch key are used to start the genera-
tor and to turn the generator off.
RECEPTACLES
The following single phase, 60 Hz outlets on the control panel
can be used for operating appropriate equipment, electrical
lighting, tools, and motor loads: 2 x 120 Volt duplex GFCI
20 Amp receptacles, and one 240 Volt AC, 30 Amp receptacle.
A 240 Volt AC, 20 Amp receptacle plugged into the side of
the removable control panel is available when the panel is
detached.
RECOIL STARTER GRIP
The recoil starter is pulled to start the machine.
REMOVABLE CONTROL PANEL
The removable control panel can be wall-mounted for use with
the control panel cord for operation in a variety of locations.
10 — English
load indicators monitor the load only
™