Features - RIDGID RD6800 Série Manuel De L'opérateur

FEATURES

PRODUCT SPECIFICATIONS
ENGINE
Engine Type .......................Yamaha MZ360, 4 Stroke, OHV
Bore x Stroke ............................................. 85 mm x 63 mm
Cooling System ...................................................Forced Air
Compression Ratio ...................................................... 8.1:1
Starting System ......................................................... Recoil
Ignition System ............................................................T.C.I.
Spark Plug .....................................................NGK BPR4ES
Engine lubricant Volume...........................................1.1 qt.
Fuel Volume ................................................................ 8 gal.
KNOW yOUR GENERATOR
See Figure 3.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator
against electrical overload. The circuit breaker may be reset
by pressing the circuit breaker reset button.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
CHOKE LEVER
The choke lever is used when starting the engine.
EXTENSION CORD
The 25-ft. extension cord (Model # RDEC25) has a 120/240
Volt, 20 Amp twist lock plug and a 12 Volt DC engine con-
trol connector on each end. When using this cord with the
removable control panel, appropriate equipment can be
powered through the 2 x 120 Volt duplex GFCI outlets on
the removable control panel.
FUEL TANK WITH FUEL GAUGE
The fuel tank with fuel gauge has a capacity of 8 gallons.
FUEL VALVE
The flow of fuel through the generator is controlled by the
position of the fuel valve.
GenSmart™ MONITORING SySTEM
The GenSmart monitoring system tracks usage and load
and alerts the operator when periodic engine maintenance
is needed.
NOTE: GenSmart
load indicator monitors the load only
™
GENERATOR
Rated Voltage .....................................................120V/240V
Rated Amps ..................................................... 56.7A/28.3A
Rated Output ..........................................................6,800 W
Maximum Output....................................................8,500 W
Rated Frequency ........................................................60 Hz
DIMENSIONS
length ....................................................................... 31 in.
Width .......................................................................... 30 in.
Height ......................................................................... 27 in.
Weight .................................................................... 228 lbs.
for the 120 Volt, 20 Amp GFCI outlets on the removable
control panel. It does not measure load on the 240 Volt, 30
Amp outlet.
GROUND TERMINAL
The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
OFF SWITCH
The generator has two off switches: one on the removable
control panel, and one on the stationary control panel. To
turn the engine off, press and hold the OFF switch until the
engine stops.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAINAGE BOLT
When changing the engine lubricant, the oil drainage bolt is
loosened to allow old engine lubricant to be drained.
RECEPTACLES
The following single phase, 60 Hz outlets on the control panel
can be used for operating appropriate equipment, electrical
lighting, tools, and motor loads: 2 x 120 Volt duplex GFCI 20
Amp receptacles, and one 240 Volt AC, 30 Amp receptacle.
A 240 Volt AC, 20 Amp receptacle plugged into the side of
the removable control panel is available when the panel is
detached.
RECOIL STARTER GRIP
The recoil starter is pulled to start the machine.
REMOVABLE CONTROL PANEL
The removable control panel can be wall-mounted for use
with extension cords for operation in a variety of locations.
10 — English