Generator Capacity; Power Management - Ridgid Rd9C7000Ag Manuel De L'opérateur

ELECTRICAL
GFCI receptacles do not protect against short circuits,
overloads, or shocks.
The GFCI receptacles can be tested with the TEST and
RESET buttons.
To test:
 Depress the TEST button. This should cause the Reset
button to pop out.
 To restore power, depress the RESET button.
Perform this test monthly to ensure proper operation of the
GFCI. If the generator is stored outdoors, unprotected from
the weather, test the GFCI receptacle before each use.

GENERATOR CAPACITY

Make sure the generator can supply enough continuous (run-
ning) and surge (starting) watts for the items you will power
at the same time. Follow these simple steps.
1. Select the items you will power at the same time.
2. Total the continuous (running) watts of these items. This is
the amount of power the generator must produce to keep
the items running. See the wattage reference chart at right.
3. Estimate how many surge (starting) watts you will need.
Surge wattage is the short burst of power needed to
start electric motor-driven tools or appliances such as a
circular saw or refrigerator. Because not all motors start
at the same time, total surge watts can be estimated by
adding only the item(s) with the highest additional surge
watts to the total rated watts from step 2.
Example:
Tool or Appliance
Quartz Work Light
(1000 Watt)
Reciprocating Saw
Drill (1/2 inch,
5.4 amps)
Circular Saw (Heavy
Duty, 7-1/4 in.)
Demolition hammer
4560 Total
Running Watts
Highest Starting Watts
Total Starting Watts Needed
Running Additional
Watts* Starting Watts*
1000 0
960 960
600 900
1400 2300
600 1200
2300 Highest
Starting Watts
Total Running Watts
+ 2300

POWER MANAGEMENT

To prolong the life of the generator and attached devices, it
is important to take care when adding electrical loads to the
generator. There should be nothing connected to the genera-
tor outlets before starting its engine. The correct and safe way
to manage generator power is to sequentially add loads as
follows:
1. With nothing connected to the generator, start the engine
as described later in this manual.
2. Plug in and turn on the first load, preferably the largest load
you have.
3. Permit the generator output to stabilize (engine runs smoothly
and attached device operates properly).
4. Plug in and turn on the next load.
5. Again, permit the generator to stabilize.
6. Repeat steps 4 and 5 for each additional load.
Never add more loads than the generator capacity. Take special
care to consider surge loads in generator capacity as previously
described.
NOTICE:
Do not overload the generator's capacity. Exceeding
the generator's wattage/amperage capacity may
damage the generator and/or electrical devices
connected to it.
Tool or Appliance
DIY/Job Site
Quartz Halogen Work Light
Airless Sprayer − 1/3 HP
Reciprocating Saw
Electric Drill − 1/2 HP
Circular Saw − 7-1/4 in.
Miter Saw − 10 in.
Planer/Jointer − 6 in.
Table Saw/Radial Arm Saw −
10 in.
Air Compressor − 1 HP
*Wattages listed are approximate. Check tool or equipment for actual wattage.
4560
6860
9 — English
Estimated* Estimated*
Running Additional
Watts Starting Watts
1000 0
600 +1200
960 +960
600 +900
1400 +2300
1800 +1800
1800 +1800
2000 +2000
1600 +4500