Mop Washing
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. To manually start washing,
tap the corresponding button in the app.
Press any button to stop washing.
Notes:
• To ensure the robot automatically washes the mop
cloths, start it from the dock and avoid moving the
dock during cleaning.
• To avoid burns from hot water, do not touch the clean
water dispensers.
• Mop wash frequency and mode can be modified in the
app.
Emptying
After cleaning, the robot will return to
the dock and auto-emptying will begin
as needed. To manually start emptying,
press
on the docked robot or tap the
corresponding button in the app. Press
any button to stop emptying.
Notes:
• When emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto-emptying can be disabled in the app.
• Avoid frequent manual emptying.
• Do not use without dust container cover or disposable
dust bag installed in place.
Drying
After mop washing or after cleaning, drying
will begin as needed. To manually start or
stop drying, tap the corresponding button in
the app.
Notes:
• Drying duration can be modified in the app.
• Auto-drying can be disabled in the app.
• Stay away from the drying air outlets during drying.
Charging
After cleaning, the robot will automatically
return to the dock to charge. Press
send the paused robot back to the dock. The
power indicator light will breathe during
robot charging.
Note:
If the robot fails to find the dock, it will
automatically return to its starting position. Place the
robot on the dock manually to recharge.
Error
If an error occurs, the power indicator light
will flash red or status indicator light will be
steady red. A pop-up notification will appear
in the app and a voice alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Resetting the System
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system by removing the magnetic
top cover and pressing the Reset button.
11
Note:
After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to
factory settings.
Restoring Factory Settings
If the robot does not function properly after
a system reset, power it on. Press and hold
and at the same time, press the Reset button
until you hear the "Restoring factory settings.
This will take about 5 minutes." voice
message. The robot will then be restored to
to
factory settings.
Routine Maintenance
D
Notes:
• The product must be switched off and the plug must
be removed from socket outlet before cleaning or
maintaining the product.
• The frequency of replacement may vary with the actual
situation. If abnormal wear occurs, replace the parts
immediately.
Main Brushes
D1
* Clean every 2 weeks and replace every 6-12 months.
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brushes
D1-4—Main Brush Bearing
D1-5—Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D1-6—Lift the main brushes and pull them
out, remove bearings and remove
any entangled hair or dirt at both