Publicité
The guarantee card must be carefully completed in full,
and the retailer's or installation technician's invoice should also be attached:
Device type :
Installation technician:
Date of entry into service:
User's name:
Adress:
Tel :
Date of purchase:
This information is for ALTECH only and will not be communicated outside the company.
Electrical power supply
- Do not damage or modify the power cable or plug. Do not place heavy objects on the power cable. Do not pull on the cable or bend it
excessively. Such actions may cause electrical damage that can lead to a fire or electric shock.
- Do not connect or disconnect the plug with wet hands; there is a risk of electric shock.
- Do not electrically overload the wall socket, with too much electrical equipment. This can cause a fire or electric shock.
- The device should be connected to standard 230 V AC, 50/60 Hz power socket, with two pins and an earth connection (type E female wall
socket, accepting type E/F male plugs – compliant with EEC7/7).
- The earth should be connected through a 30 mA differential circuit breaker. This is the only safety system protecting persons and animals,
and the wall-mounted mains power socket should therefore be protected by this circuit breaker, installed by a qualified electrician, to ensure
complete safety.
- The electricity supply must correspond to that specified on the device's label, otherwise there will be a risk of fire, electric shock or incorrect
operation. If you don't know the characteristics of your electricity supply, contact your local electricity distributor.
- Do not leave the power cable close to objects radiating heat. The cable outer sheath can melt, leading to a fire and/or electric shock.
- Check that the power cable is properly extended, with no knots, when the electricity is switched on. Knots in the cable or similar bending
can lead to fire or electric shock.
- Before carrying out any work on the device, or in the event of a malfunction, switch off the device and disconnect the plug from the electrical
supply socket, with dry hands and without pulling on the cable.
CAUTION
- During storms, switch off the device and disconnect the power cable from the socket (note that the data memory will be erased when you
switch off the power supply).
- Switch off the electrical supply and disconnect the power cable if the device is not going to be used for a long period, during holidays for
example.
- If the power cable plug, connected to the mains power socket, becomes excessively dusty, disconnect the plug and clean it with a clean,
dry cloth.
- Do not connect the device to a socket that is also used for other electrical equipment, such as an air conditioner, household appliances or
audio systems. Such equipment generates electrical noise that can interfere with the operation of your equipment.
Handling
- Do not allow any metal object to fall into the device. Do not spill any liquid or flammable substance onto it. When coming into contact with
internal high voltages, such substances may cause fire or electric shock. If an object should fall into the device or if liquid is spilt on it, switch
off the device's electrical supply immediately, and disconnect the power cable plug from the mains power socket, with dry hands. Then
contact our customer support.
- Do not use flammable aerosol products close to the device. If aerosol gas should come into contact with electrical components inside the
device, there is a risk of fire.
- The device contains high voltages. If the device is opened, do not leave metal objects inside and do not touch any internal components as
there is a risk of burns or electric shock.
- Do not exert excessive pressure on the device covers and instrument panels as there is a risk of damage and/or injury.
- Never lift the equipment by its hydraulic or electrical connections.
- The manufacturer accepts no liability whatsoever if the above safety precautions are not fully observed.
Servicing
- Only the servicing procedures described in the technical documentation should be carried out. If other servicing is required, contact our
customer support.
- The device should be kept clean; an accumulation of dust can prevent proper operation.
Serial N°:
Siren N° (mandatory):
Signature and stamp:
Email :
Signature :
4
Publicité
