Switching Between Intercom Modes; Troubleshooting; Soft Reset; Reset Pairing - Agv Insyde Mode D'emploi

4.4 SWITCHING BETWEEN INTERCOM MODES

Your INSYDE unit can work in only one intercom mode at a time.
The current intercom mode is indicated by the color of the LED:
• When in DMC intercom mode, the LED flashes green at approximately 4-second intervals.
• When in Bluetooth
To switch from between intercom modes:
• On your unit, tap
→ The color of the flashing LED changes and a voice message indicates the current
intercom mode.

5 TROUBLESHOOTING

5.1 SOFT RESET

If your INSYDE stops responding, reset it in one of these ways.
• Turning it off and then on again (see Getting Started).
• Using the supplied USB cable, connect your unit to the computer or wall charger for 30".

5.2 RESET PAIRING

This option deletes all paired units and devices.
To reset pairing:
1. Confirm your unit is in Standby Bluetooth
If your unit is not in Bluetooth
x1
For more information, see Switching between Intercom modes.
intercom mode, the LED flashes blue at approximately 4-second intervals
®
and .
x1
intercom mode, tap
®
intercom mode (LED flashes blue slowly).
®
and
26
.