Cutting; Mitre Cutting - Husqvarna TS70 Manuel D'utilisation

Voltage switch (TS90 2 Hp)
The machine is equipped with an electronic system that
makes it possible to use 115V or 230V at 60 Hz.
CAUTION! The motor must be off and the
!
current supply to the machine must be
cut when setting it to 115V or 230V. Make
sure the outlet voltage corresponds to
one of the two alternatives available on
the machine. Cutting ability can be
affected and fuses blown or overload
protection triggered if this setting is
incorrect.
The switch is on the side of the motor and has two
positions.
• Make sure the voltages on the machine and in the
outlet are in agreement. Change the setting on the
machine if they are not the same.
• Remove the cover. Put the control to the desired
position and screw back the cover to avoid inadvertent
changes to the control.

Cutting

The side table is adjustable out/in in fixed positions.
• Use the cutting guide when cutting. Loosen the snap
fastener and adjust the cutting guide using the scale
on the conveyor cart. The cutting guide can be folded
out for angled cuts. Use the angle markings on the
cutting guide to set the correct angle.
OPERATING

Mitre cutting

!
The cutting arm can be angled in two positions, 45° (stop)
and 22.5° (marking).
The stop depth does not need changing as it is adjusted
automatically when angled.
• Loosen the lock knob for the depth setting and raise
the blade.
• Loosen the lock knob for miter cutting and set the
required angle.
- 45° ° ° ° : Angle the cutting arm until the head of the screw
touches the plate.
WARNING! Loosen the depth setting lock
and raise the blade before it is angled.
–
English 17