Operation; Cutting Blades - Husqvarna FS 500 E Manuel D'utilisation

• Stop the product when you replace the diamond
tools. Turn the ON/OFF switch to 0 and push the
machine stop button.
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
CAUTION: Do not use an extension cable
longer than 25 m. Do not use extension
cables with wires weaker than 2.5 mm
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the instructions that are supplied with the
cutting blade by the cutting blade manufacturer.
• Before each operation of the product, do these
steps:
a) Do the daily maintenance. Refer to
on page 55 .
b) Make line marks for all cuts. Prepare the
operation sequence carefully to prevent injury
and damage.
c) Adjust the handlebar to an applicable operation
position. Refer to
page 51 .
d) Fill the water tank.
e) Make sure that the pointer is aligned with the
cutting blade. Refer to
the cutting blade on page 53 .
f) Connect the power plug of the product into the
mains outlet.
50
Maintenance
To adjust the handle height on
To align the pointer with
• Do the maintenance to make sure that the product
operates correctly. Refer to
55 .

Operation

g) In some conditions you must reverse phases.
2
.
h) Turn the machine stop button clockwise to make
sure that the button is disengaged.
i) Make sure that you know in which direction the
cutting blade rotates.
j) Make sure that the cutting blade and the blade
guard is correctly installed.

Cutting blades

WARNING: Do not use a cutting blade for
other materials than which it is made for.
WARNING: Only use diamond blades for
wet cutting. The diamond blade must be
applicable to the same speed or a higher
speed than the value given on the product
type plate. Only use diamond blades that
are in compliance with national or regional
standards, for example EN13236 or ANSI
B7.1.
The cutting blade manufacturer gives warnings and
recommendations for the operation and correct
maintenance of the cutting blade. Those warnings are
supplied with the cutting blade.
Maintenance on page
1024 - 002 - 18.06.2019