Husqvarna FS 500 E Manuel D'utilisation page 58

9. Tighten the front tension screw and nut.
10. Tighten the 4 screws that holds the motor in position.
11. Install the drive belt cover and the screws.
To lubricate the product
Lubricate the components that follow. Lubricate until the
grease can be seen at the edges. For correct grease,
Technical data on page 60 .
refer to
1. Connect the grease gun to the pump.
58
2. Lubricate the blade shaft bearings (A) and the
bushings (C), on the left side and the right side of the
product.
A
3. Lubricate the lubrication points of the lever for cutting
depth adjustment (B).
4. Lubricate the nut of the cutting depth wheel.
Lubricate above and below the nut.
5. Turn the cutting depth wheel clockwise and
counterclockwise again and again and lubricate
equally.
B
C
1024 - 002 - 18.06.2019