Maintenance; Maintenance Schedule - Husqvarna FS 500 E Manuel D'utilisation

CAUTION: Do not move the product
from side to side to align the cutting
blade with the marks.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
A spare parts list is available to download at the web site
www.husqvarnacp.com. In the "SUPPORT" section of
the web site you find the section where you can
download.

Maintenance schedule

Maintenance

Clean the external surfaces of the product with water. Do not use high-pressure
washer.
Do a general inspection.
Adjust the drive belt.
Do a check of the machine stop button. Refer to
stop button on page 48 .
Do a check of the blade guards. Refer to
page 49 .
Do a check of the cutting blade. Refer to
Do a check of the blade shaft.
Lubricate the product. Refer to
To clean the product
WARNING: Use protective glasses. When
you clean the product, dirt and harmful
material can eject from the product.
CAUTION: A blocked air intake decreases
the performance of the product and can
cause the motor to become too hot.
• Let the product become cool before you clean it.
• Do not clean electrical components with water.
1024 - 002 - 18.06.2019
Maintenance
To do a check of the machine
To do a check of the blade guard on
Cutting blades on page 50 .
To lubricate the product on page 58
To do before the maintenance
• Park the product on a level surface and stop the
motor. Push the machine stop button on the control
panel to prevent accidental start during
maintenance.
• Always pull out the plug from the mains outlet before
you clean, do maintenance or assemble the product.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Put clear signs around the maintenance area to give
a warning to bystanders that maintenance work is in
progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
• Use a weak cleaning agent. Put on protective gloves
to prevent skin irritation.
• Always clean all the equipment at the end of the
work day. Do not use a high-pressure washer to
clean the product.
• Remove blockage from all air openings.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can become damaged.
• Examine the electrical parts for damage. Do not
operate a product that has damaged electrical parts.
Daily Weekly Monthly
X
X
X
X
X
X
X
X
55