Diamond Blades - Husqvarna FS 500 E Manuel D'utilisation

Diamond blades

WARNING: Make sure that the diamond
blade rotates in the direction of the arrows
shown on the diamond blade.
CAUTION: Always use a sharp diamond
blade.
There is a wide range of diamond blades that is used for
different operations. From new made concrete to
concrete and asphalt that has become hard and for
different hardness classes.
Diamond blades has a steel core with segments that are
made of industrial diamonds.
Water cooling system
Always use water during operation to keep the
temperature of the diamond blades down. The water
cooling system also increases the lifetime of the
diamond blades and prevents dust buildup.
Make sure that the water supply is not clogged.
To sharpen the diamond blades
Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause the
diamond segments to come loose.
• Decrease the cutting depth and the motor speed for
a short time to sharpen the diamonds on the
diamond blade.
Diamond blades for wet cutting
CAUTION: Always use a blade flange
dimension that is specified for the current
blade dimension. Do not use blade flanges
that are damaged.
During the operation, the friction causes the diamond
blade to become very hot. If the diamond blade
becomes too hot, it will decrease the blade tension or
make the core crack.
Let the diamond blade become cool before you touch it.
• Diamond blades for wet cutting must be used with
water to keep the diamond blade core and segments
1024 - 002 - 18.06.2019
cool during cutting. Diamond blades for wet cutting
can not be used dry.
• If you use diamond blades for wet cutting without
water, the diamond blade can become too hot. This
gives bad performance, blade damage and is a
safety risk.
To adjust the handle height
The height of the handle can be adjusted to the correct
height.
1. Loosen the screw (A).
B
2. Set the position for the necessary work height (B).
3. Tighten the screw (A).
To install the cutting blade
1. Stop the motor and disconnect the product from the
mains socket.
2. Turn the cutting depth wheel counterclockwise.
3. Stop the water supply and disconnect the water hose
from the blade guard.
A
51