Husqvarna FS 500 E Manuel D'utilisation page 54

To engage and disengage the parking
brake
1. Engage the parking brake (B) to hold the product in
position.
A
2. Disengage the parking brake (A) to move the
product.
To start the product
1. Make sure that the cutting blade slightly touches the
ground.
2. Turn the ON/OFF switch to 1 to start the product. In
less than 5 seconds the product operates at the
correct operation speed.
To stop the operation
1. Lower the cutting depth lever.
2. Unwind the cutting blade from the groove.
3. Lift the cutting depth lever.
4. Stop the water supply.
To stop the product
WARNING: The cutting blade rotates for a
while after the motor stops.
54
B
1. Turn the ON/OFF switch to "0" to stop the motor.
2. Keep the cutting blade in the cut. Make sure that the
cutting blade does not rotate before you lift it up.
3. Engage the parking brake.
4. Pull out the power plug.
To cut the surface
1. Open the water supply.
2. Make sure that the water tube in the blade guard is
open. Each side of the cutting blade must have
sufficient supply of water.
3. Do a test of the water supply for pressure and
quantity (flow) before you cut.
4. Run the motor on full power.
5. Lower the lever that locks the cutting depth. The
depth refers to the specifications of the operation.
Only cut the depth that is necessary to prevent more
wear on the cutting blade and the product.
6. Make a cut as a guide, approximately 20-30 mm.
7. Do cut increments of 50 mm until you get the
necessary depth.
8. Pull up the lever that locks the cutting depth.
9. Cut only in a line, align the cutting blade with the
guide marks.
10. Slowly push the product forward and make sure that
the front guide and the cutting blade are aligned with
the marks.
1024 - 002 - 18.06.2019