Basic Working Techniques; Mitre Cutting; Plunge Cutting; Transport And Storage - Husqvarna TS60 US Manuel D'utilisation

• Stand upright. Keep distance between your face and the
cutting blade. Place both hands on the work piece as far
away from the cutting blade as possible. If plunge function
is used is one hand placed on the cutting handle.
Use and care
• This machine is designed and intended for cutting tile and
stone. All other use is improper.
• Experience is very important when running the machine.
A skilled worker is highly recommended.
• The machine is intended for use in industrial applications
by experienced operators.
• Check that the machine is assembled correctly and do not
show any signs of damage.
• Always perform daily maintenance before starting the
engine. See instructions in the section "Maintenance".
• Do not overload the machine. Overloading can damage
the machine.
• The blade shall be intended for the material to be cut.
• If you are uncertain of what blade to use contact your local
service dealer.
• Keep tools sharp and clean in order to enable safer work.
• Keep all parts in good working order and ensure that all
fixtures are properly tightened. Replace all worn or
damaged decals.
• Never leave the machine unsupervised with the motor running.
• Feed the work piece against the rotation of the blade only!
• Observe care when lifting. You are handling heavy parts,
which imply the risk of pinch injuries or other injuries.
Water cooling to the blade
• Water cooling through the blade guard should always be
used when miter cutting and when diagonal cutting 20"
(500 mm) tile. The cut is longer than the cart and at the
start of the cut, the blade will not pick up any water from
the slot in the cart.
• Turn the water knob slightly to redirect water to the blade.
• When reaching the slot in the cart, the water to the blade can
be shut off in order to keep the area as clean as possible.
14 –
English
OPERATING

Basic working techniques

Mitre cutting

The cutting arm can pivot up to 45° degrees. There is a
marking at 22.5°.
• Loosen the lock knob for miter cutting and set the required
angle.
• Lock the knob.

Plunge cutting

The cutting arm is spring loaded and adjustable up and down.
• Loosen the lock knob for the depth adjustment. With the
handle on the cutting arm the cutting blade can adjusts up
and down and create a plunge cut in the work piece.

Transport and storage

Stop the motor and disconnect the power cable before lifting
or moving the machine.
• Secure the equipment during transportation in order to
avoid transport damage and accidents.
• Ensure that the conveyor cart is locked and that the
extension slide is locked in its inner position.
• Store the equipment in a lockable area so that it is out of
reach of children and unauthorized persons.
• For transport and storage of Blades, see the section
"Blades".
• Lift the machine at the short ends.