Fit The Blade; Blade Settings; Depth Stop Adjustment - Husqvarna TS70 Manuel D'utilisation

Fit the blade

WARNING! Shut down the machine and
!
disconnect the power plug.
• Loosen the lock knob. Open the blade guard.
• Hold down the button for locking the blade shaft.
• Remove the nut. Remove the blade flange.
• Check that the blade, blade flange and blade shaft are
undamaged. Clean the contact surfaces of the blade
and the blade flange.
• Fit the blade, blade flange and nut. Make sure that the
blade will rotate in the direction indicated by the arrow
on the blade.
• There are two fixed positions for the spray nozzle to
adapt its position to the size of blade (Ø250 or Ø230
mm blades).
• Close the blade guard. Tighten the locking knob.
10 – English
ASSEMBLING AND ADJUSTMENTS

Blade settings

Depth stop adjustment

Set the depth stop so that the blade gets maximum depth
without cutting into the cart. This allows the stream of
water in the cart to be picked up by the blade and
distributed as the working piece is cut.
CAUTION! This must be done while the
!
blade is not rotating.
The depth stop should be adjusted when
switching to other blade sizes. Check the
stop depth regularly or there is a risk that
the cutting slot and the water system will
not function correctly.
• Loosen the locking knob for depth setting (1) and
lower the cutting arm.
• Loosen the lock nut (3).
• Loosen the depth stop adjustment knob (2).
2
• Push down the cutting arm until the blade hits the
bottom of the slot in the cart.
• Hold down the cutting arm in this position.
• Screw down the knob (2) for setting the stop depth
until the end of the knob abuts the underlying surface
in order to set up the stop depth of the blade. Turn
another turn to raise the head from the cart slightly.
• Tighten the locking nut (3).
• Tighten the locking knob for depth adjustment (1) with
the cutting arm still pushed down to its lowest position.
• Check the position of the blade by moving the
conveyor cart to its forward and rear end position. The
blade should never hit the cart.
3
1
2
3
1