Assembling And Adjustments; Fitting The Blade - Husqvarna K970 II Ring Manuel D'utilisation

Fitting the blade

WARNING! It is forbidden to reconstruct
!
a used blade. A used blade may be
weakened. A reconstructed blade can
crack or break into pieces and seriously
injury the operator or other persons.
WARNING! Check that the blade is not
!
damaged before fitting it on the machine.
Damaged blades can disintegrate and
cause serious personal injury.
NOTICE! Replace the drive wheel when fitting a new
blade. A worn drive wheel can result in the blade
slipping and becoming damaged.
Inadequate water flow drastically shortens the life of the
drive wheel.
• Wipe off any dirt from the surface of the blade.
• Loosen the locking nuts on the support roller cover.
• Unscrew the adjuster screws a few turns.
10 – English

ASSEMBLING AND ADJUSTMENTS

• Loosen the knob to offload the springs.
• Remove the four screws holding the support roller
guard using a 6 mm hex key and lift off the cover.
• Fit the blade.
• The blade has a groove (1) on one side that acts a the
guide groove for the support rollers. Ensure that the V-
shaped edge of the blade enters the drive wheel and
that the blade's guide groove fits in the guide rollers.
• Ensure that the V-shaped edge of the blade enters
the drive wheel and that the blade's guide groove fits
in the guide rollers. See instructions in the section
"Blades".
• Press in the guide roller if necessary, so that it climbs
into the groove on the blade.