Fitting The Blade - Husqvarna FS 3500 G Manuel D'utilisation

• Turn the Engine start switch to the engines start position
until the engine starts, then release the switch. It will
return to ignition on position automatically. If the engine
does not start, repeat these steps.
• Push the Forward/Reverse control lever forward for
forward saw movement, or to the rear for reverse saw
movement.
The further you push the lever the faster the speed. For
more information, see the "Technical data" section.
WARNING! Do not put transmission in
!
neutral while the machine is parked on a
grade or hill. The operator will lose control
and injury or damage could occur.
Adjust the resistance on the Forward/Reverse control lever
with the nut on the side of the lever.
OPERATING

Fitting the blade

!
NOTICE! Check the blade's direction of rotation. The arrow
on the blade and the blade guard indicates the direction of
rotation.
1 Transport the machine to within the cutting area and check
your surroundings according to the information found
under the heading Cutting area safety.
2 Set Engine start switch to ignition on position.
3 Raise the saw to a high position using the Raise/lower
switch on the Forward/Reverse control lever.
4 Set the engine start switch to OFF position.
5 Press the Machine stop on the control panel.
6 Turn off the Water valve.
3
• Loosen the blade guard front bolt and lift the blade guard
latch.
• Raise blade guard front and use quick release pin to lock
it in upright position.
WARNING! Always set the engine start
switch to the OFF position before installing
the blade.
2 4
6
5
– 17
English