Key To Symbols; Symbols On The Machine - Husqvarna FS 3500 G Manuel D'utilisation

Symbols on the mac hine:
Some of the symbols belo w refer to the CE market.
W ARNING! The machine can be a dangerous
tool if used incorrectly or carelessly, which can
cause serious or fatal injury to the operator or
others.
Please read the operator's manual carefully
and make sure you understand the instructions
before using the machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
All displacement of the machine outside the
cutting area shall be carried out with the tool
not in rotation.
Remove the blade prior to hoisting, loading,
unloading and transporting the machine.
Arrow on tool guard indicating
the direction of tool rotation.
The guards should always be fitted on the
machine. Never allow blade exposure to
exceed 180 ° .
Check the cutting attachment. Never use blunt,
cracked or damaged equipment.
The blades should be marked with the same or
a higher speed than that stated on the
machine's rating plate. A cutting blade running
at a too high speed can break or cause serious
damage.
Do not use the machine near ignitable
substances or gases.
WARNING! Dust forms when cutting, this can
cause injuries if inhaled. Use an approved
breathing mask. Avoid inhaling exhaust fumes.
Always provide for good ventilation.
Hot surface.
Machinery hazard! Always keep all parts of
your body away from blade and all other
moving parts.
Caution, risk of cutting
2 –
English
KEY T O SYMBOLS
Water supply adjustment
Lower blade
Switch for lower and raise the blade
Ignition on
Engine starts
Engine stops
Machine stop
Transmission stop
Refuelling Unleaded fuel only
Choke control
Engine oil
Dipstick, maintain proper engine oil level
Do not raise the saw when checking engine oil
level.
Parking brake
Activated / Deactivated