Troubleshooting; Incidents During Sawing - Husqvarna FS 3500 G Manuel D'utilisation

Incidents during sawing

CAUTION! If the engine or blade stops for any reason, raise the blade completely from the cut. Set the Engine start switch to
STOP position. Press the Machine stop on the control panel. Inspect the machine thoroughly before restarting the engine.
• Entrust all repairs to your authorized dealer only
Problem
Engine stops during sawing
The diamond blade stops during sawing
Saw lowers too fast
The blade cuts too slowly.

TROUBLESHOOTING

Cause
Engine out of fuel.
Lack of water signals the
Water safety switch to stop
the engine
The Machine stop has been
pressed down
Excessively fast cutting will
stall the engine
Circuit breaker fuse is blown Inspect and replace fuses
Drive belt tension is
inadequate
The valve that controls the
saw lowering is open too
much.
The blade has become dull
or it is too high feeding
pressure
Possible action
Refill with fuel
Disengage the Water safety switch and check water
supply, then restart the engine.
Reset the machine stop by pulling the knob outward.
Listen to the sound of the engine. If the engine starts to
slow down compensate by pulling Forward/Reverse
control lever backwards to decrease feeding and
prevent stalling the blade.
The ROSTA tensioner or drive belt needs to be
replaced.
The lowering rate of the saw can be adjusted using the
Saw lowering speed control knob on/under the
hydraulic pump. If the saw lowers too quickly, turn the
knob clockwise until an adequate lowering rate is set.
Decrease the cutting depth and engine speed for a
short time
– 31
English