Federal And California Emissions; Your Warranty Rights And Obligations; Manufacturer ' S Warranty Coverage; Owner ' S Warranty Responsibilities - Husqvarna FS 3500 G Manuel D'utilisation

Masquer les pouces Voir aussi pour FS 3500 G:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FEDERAL AND CALIFORNIA EMISSIONS CONTROL
YOUR WARRANTY RIGHTS AND
OBLIGATIONS
The Environmental Protection Agency and Husqvarna
Construction Products are pleased to explain the evaporative
emission control system (EECS) warranty on your 2011 and
later small off-road engine (SORE) or equipment. New
SOREs or equipment must be designed, built, and equipped
to meet the new stringent anti-smog standards. Husqvarna
Construction Products must warrant the EECS on your
SOREs or equipment for the period of time listed below
provided there has been no abuse, neglect, or improper
maintenance of your SOREs or equipment.
Your EECS may include parts such as the carburetor or fuel
tanks, fuel lines, fuel caps, valves, canisters, filters, vapor
hoses, clamps, connectors, and other associated
components. The covered parts for 2011 and later are given
below. When a warrantable condition exists, Husqvarna
Construction Products will repair your SORE engine or
equipment at no cost to you, including diagnosis, parts, and
labor.
MANUFACTURER' ' ' ' S WARRANTY
COVERAGE
This EECS is warranted for two (2) years. If any evaporative
emission-related part included in the list of warranted EECS
parts for your equipment is defective, the part will be repaired
or replaced by Husqvarna Construction Products.
OWNER' ' ' ' S WARRANTY
RESPONSIBILITIES
As the SORE owner, you are responsible for performance of
the required maintenance listed in your owner's manual.
Husqvarna Construction Products recommends that you
retain all receipts covering maintenance on your SORE, but
Husqvarna Construction Products cannot deny warranty
solely for the lack of receipts. As the SORE owner you should
be aware that Husqvarna Construction Products may deny
you warranty coverage if your SORE or a warranted EECS
part has failed due to abuse, neglect, or improper
maintenance or unapproved modifications. You are
responsible for presenting your SORE to a Husqvarna
Construction Products service center as soon as the problem
exists. The warranty repairs should be completed in a
reasonable amount of time, not to exceed 30 days. If you have
a question regarding your warranty coverage, you should
contact the Husqvarna Construction Products service center
at 1-800-288-5040 or www.USA.husqvarnacp.com.
GENERAL EMISSION WARRANTY
COVERAGE
Husqvarna Construction Products warrants to the ultimate
purchaser and each subsequent purchaser that your SORE
or equipment is:Designed, built, and equipped to conform to
all applicable regulations; and Free from defects in materials
or workmanship that cause the failure of a warranted part to
be identical in all material respects to that part as described
in the original Husqvarna Construction Products Application
for Certification. The warranty period begins on the date the
equipment is delivered to the ultimate purchaser or first
placed into service. The warranty period is two (2) years.
Subject to certain conditions and exclusions as stated below,
the warranty on covered emission-related parts is as follows:
1 Any warranted part that is not scheduled for replacement
as required maintenance in the written instructions
supplied is warranted for the warranty period stated
above. If the part fails during the warranty period the part
will be repaired or replaced by Husqvarna Construction
Products according to subsection (4) below. Any such part
repaired or replaced under warranty will be warranted for
the remainder of the period.
2 Any warranted part that is scheduled for regular
inspection in the written instructions supplied is warranted
for the full warranty period. Any such part repaired or
replaced under warranty will be warranted for the
remaining warranty period.
3 Any warranted part that is scheduled for replacement as
required maintenance in the written instructions supplied
is warranted for the full warranty period before the first
scheduled replacement date for that part. If the part fails
before the first scheduled replacement, the part will be
repaired or replaced by Husqvarna Construction Products
according to subsection (4) below. Any such part repaired
or replaced under warranty will be warranted for the
remainder of the period prior to the first scheduled
replacement point for the part.
4 Repair or replacement of any warranted part under the
warranty provisions herein must be performed at a
Service Center at no cost to the owner.
5 Notwithstanding the provisions herein, warranty services
or repairs will be provided at all of our service centers that
are franchised to service the subject engines or
equipment.
6 The engine or equipment owner will not be charged for
diagnostic labor that is directly associated with diagnosis
of a defective emission-related warranted part, provided
that such diagnostic work is performed at an authorized
Service Center.
7 Husqvarna Construction Products may be liable for
damages to other engine or equipment components
proximately caused by a failure under warranty of any
warranted part.
8 Throughout the warranty period stated above, Husqvarna
Construction Products will maintain a supply of warranted
parts sufficient to meet the expected demand for such
parts.
9 Any replacements part may be used in the performance of
any warranty maintenance or repairs must be provided
without charge to the owner.
10 Add-on or modified parts that are not exempted by the Air
Resources Board may not be used. The use of any non
exempt add-on or modified parts by the ultimate
purchaser or subsequent purchaser will be grounds for
disallowing a warranty claim. Husqvarna Construction
Products will not be liable to warrant failures of warranted
parts caused by the use of a non-exempted add-on or
modified part.
– 37
English

Publicité

Table des Matières
loading

Table des Matières