Husqvarna FS 3500 G Manuel D'utilisation page 18

WARNING! Check that the blade, blade
!
flanges and blade flange arbor are
undamaged. Clean the contact surfaces of
the blade and the blade flanges. Make sure
the blade and the flanges are clean and free
of dirt and debris before mounting the blade
on the machine.
The blade shaft bolt on the right hand side of
the saw has left hand threads and the blade
shaft bolt on the left hand side of the saw
has right hand threads. Replace the blade
shaft bolt and plain washer when worn or
damaged.
1 Loosen blade shaft nut which is used to clamp the blade
between the inner and outer flange.
2 Remove the outer blade flange.
3 Fit diamond blade to blade shaft.
4 Install outer flange with blade pre-installed into the inner
flange making sure that the locking pin passes through the
diamond blade and into the inner flange.
Install and tighten nut using the blade shaft wrench while
firmly holding the blade.
3
2
1
4
Lower the saw by pushing the Raise/lower switch on the
Forward/Reverse control lever downwards until the blade
touches the surface to be cut.
CAUTION! The touch should be smooth to
!
prevent damaging the blade. Use Saw
lowering speed control knob to slow down
the lowering speed. Never let the front
weight of the machine be supported by the
blade since this will damage the blade.
18 –
English
OPERATING
• Tighten the blade shaft bolt firmly using the blade shaft
wrench while resistance between diamond blade and
ground helps to achieve proper and final tightening.
• Lower blade guard front and position the blade guard latch
on the blade guard front bolt. Tighten the blade guard front
bolt.
NOTICE! Do not operate this saw without the latch engaged
and the bolt installed. Do not use if damaged.
• Test run the machine and check that no unusual sounds
occur. Unusual sounds are a sign of an incorrectly
mounted blade.
Install the blade guard
Slip on blade guards are secured with a blade guard lock
which engages the rear half of the blade guard.
Do not operate this saw without the lock engaged. Inspect
blade guards and locks frequently. Do not use if damaged.
Lower the guard onto the support spade and use moderate
force to press down the blade guard until lock engages.
Remove the blade guard
1 Disconnect the water hose from the blade guard.
2 Remove the bolt holding the blade guard.