Switching On And Normal Functioning; Playing The Legend Exp - Key B Organ Viscount Legend Expander Mode D'emploi

User Manual

4. SWITCHING ON AND NORMAL FUNCTIONING

To switch on the instrument follow these simple rules:
1. Turn the [VOLUME] potentiometer to the left (closed).
2. When using headphones, do not wear them.
3. Switch on the instrument through the [POWER] switch on the rear panel.
4. Wait until the LED light sequence on the front panel is over and the letter " M-- " appears on the display:
the instrument is now ready to be played.
5. Adjust the volume as needed and / or wear headphones if necessary.
After switching on, the instrument always recalls the following settings:
- R EVERB TYPE: HALL
3 9 1 B
-
R EVERB PRE ROTARY: POST
3 9 2 B
-
D RIVE TYPE: CLASSIC
3 9 3 B
-
R OTARY SLOW – FAST : SLOW
3 9 4 B
-
R OTARY TYPE: CLASSIC
3 9 5 B
-
R OTARY DIRECT: OFF
3 9 6 B
-
R OTARY MEMPHIS STYLE: OFF
3 9 7 B
-
P EDALS TO LOWER: OFF
3 9 8 B
-
P EDALS DIRECT: OFF
3 9 9 B
- P EDALS SUSTAIN: 0
4 0 0 B
-
P EDALS SPLIT POINT: C3
4 0 1 B
-
P ERCUSSION ON/OFF: ON
4 0 2 B
- P ERCUSSION SOFT/NORMAL: SOFT
4 0 3 B
-
P ERCUSSION SLOW/FAST: FAST
4 0 4 B
-
P ERCUSSION 2nd/3rd: 3rd
4 0 5 B
-
P ERCUSSION VOLUME: 64
4 0 6 B
-
P ERCUSSION DECAY: 64
4 0 7 B
-
M ODEL TYPE: '70
4 0 8 B
- M ODEL CROSSTALK: 64
4 0 9 B
-
M ODEL KEYCLICK: 64
4 1 0 B
-
E Q BASS: as before switching off
4 1 1 B
The functions shown in bold can be saved to Memories for later use. Saved settings can be recalled at any
time using Memories. For more information on Memories see par. 4.9.

4.1 PLAYING THE LEGEND EXP

Legend Exp
simulates the upper and lower manuals as well as the pedalboard of electromechanical organs.
From this point onward, with regards to
- upper manual refers to the Upper section
- lower manual refers to the Lower section
- pedalboard refers to the Pedals section
These sections can be played in different ways, according to the instrument(s) transmitting the signal and the
user's preferences. First, select the appropriate MIDI data reception mode, called MIDI MODE.
To select a MIDI MODE, press and hold the [ROTARY] button and then push the [DRIVE] button repeatedly.
An alternative procedure is holding down the [DRIVE] button and then [ROTARY] until the letters "MdE" appear
on the display (the same message will appear at the first access to the MIDI menu after switching on the
instrument).
Now press [VALUE +] or [VALUE -], to switch between modes. The display will show the currently selected
MIDI MODE:
- " Md1": MIDI MODE 1
4 3 6 B
- " Md2": MIDI MODE 2
4 3 7 B
- E Q MIDDLE: as before switching off
4 1 2 B
-
E Q TREBLE: as before switching off
4 1 3 B
-
D RAWBARS: UPPER
4 1 4 B
-
P RESETS: NO
4 1 5 B
-
V IBRATO/CHORUS UPPER: OFF
4 1 6 B
-
V IBRATO/CHORUS LOWER: OFF
4 1 7 B
-
G LOBAL TUNING: 0
4 1 8 B
-
G LOBAL TRANSPOSE: 0
4 1 9 B
-
G LOBAL TONE CONTROL: as before switching off
4 2 0 B
- G LOBAL LOCK DRAWBARS: as before switching off
4 2 1 B
-
G LOBAL LOCK CONTROLS: as before switching off
4 2 2 B
-
G LOBAL ROTARY PEDAL MODE: as before switching off
4 2 3 B
- G LOBAL EXPRESSION PED. TYPE: as before switching off
4 2 4 B
-
G LOBAL EXPRESSION PED. MIN.: as before switching off
4 2 5 B
-
M IDI MODE: as before switching off
4 2 6 B
-
M IDI CHANNEL UPPER: as before switching off
4 2 7 B
-
M IDI CHANNEL LOWER: as before switching off
4 2 8 B
-
M IDI CHANNEL PEDAL: as before switching off
4 2 9 B
- M IDI SPLIT POINT UPPER/LOWER: C3
4 3 0 B
-
M IDI LOWER OCTAVE: OFF
4 3 1 B
-
M IDI THRU: as before switching off
4 3 2 B
Legend Exp
,
EN - 8