Tecno-gaz Master Flux Plus Mode D'emploi page 48

ENGLISH
The treatment will end when the orthodontist has finished the procedure on the patient.
To end treatment:
-
Shut off the NITROUS OXIDE supply by turning (counter-clockwise) the %N
(C – figure A10) to the end stop (0%).
-
Administer (as at the beginning of treatment) a flow of 3 Lt/min of oxygen for 2
minutes
-
Shut off the OXYGEN supply by turning (counter-clockwise) the FLOW knob (A –
figure A10) to the end stop.
- Loosen the loop that secures the tube and take the mask off of the patient.
Before signing the patient out keep him/her under observation (waiting room) for
~5÷10 minutes.
The doctor may deem it necessary to increase the observation period.
Once the doctor has finished using the device it is IMPORTANT to close the cylinders.
Close the valve on the Nitrous oxide cylinder (N2O), (turning it clockwise). Close the
valve on the Oxygen cylinder (O2), (turning it clockwise).
20
END OF TREATMENT
CLOSING THE CYLINDERS
O knob
2