Drawing Steam And Milk Foam; Foaming Milk / Hot Milk With The Cappuccinatore (Only U27.32) - Rotel Adagio Mode D'emploi

Masquer les pouces Voir aussi pour Adagio:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.7 Drawing steam and milk foam

• Press the steam / rinsing button (5). The 5 bars start to blink.
• As soon as the system is ready, the symbol
• Insert the jet (7) into the cup with the liquid to be heated.
• Turn the steam / hot water dial (6) to the right.
Please note:
Water will first come out and then steam.
• By turning back the dial (6) to 0, the process is stopped.
• Press the steam / rinsing button (5) and the coffee machine will be reset for normal
operation.
You can make steam for up to two minutes. The machine will then turn off auto-
matically. By turning the dial (6) back and forth, you can continue the process.
Caution: Very hot steam and danger of burns! Only touch the jet on the black
plastic part!
TIP:
Dried residue on the jet after making milk foam is difficult to remove. You should
therefore clean it immediately after it has cooled off!
3.8 Foaming milk / hot milk with the Cappuccinatore
Using the special foaming tool "Cappuccinatore" (7a) you can foam or heat up fresh
milk directly in to your cup.
• Mount the hose to the steam jet (7a).
• Insert the hose (A) into the receptacle with milk and place the cup under the Cap-
puccinatore (7).
• Press the steam / rinsing button (5). The 5 bars start to blink.
• As soon as the system is ready the symbol
• Turn the steam / hot water dial (6) slowly to the right.
• The milk is soaked up and fed into the cup as foam / hot milk.
• End this process by closing the steam / hot water dial (6) to the 0 position.
• Press the steam/rinsing button (5) and the coffee machine will be reset for nor-
mal operation.
You can make steam for up to two minutes. The machine will then turn off auto-
matically. By turning the dial (6) back and forth, you can continue the process.
TIP:
Dried residue on the foaming tool and jet is difficult to remove. You should therefore
clean it immediately after it has cooled off:
• Repeat the process as described above but use clear water instead of milk.
• Draw steam until clean water / steam comes out of the jet
Please note:
For optimal cleaning the "Cappuccinatore" must be dismantled from time to time (B)
and its parts rinsed under fresh, cold water.
24
13_1383_ROT_BA_AdaVero_IH.indd 24
13_1383_ROT_BA_AdaVero_IH.indd 24
(only Model U27.30)
blinks.
(only U27.33)
lights up.
06.01.14 10:23
06.01.14 10:23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

VeronaU27.32chU27.30ch

Table des Matières