Cleaning And Maintenance - Rotel La passione PLUS Mode D'emploi

A - Small cups
B - Large cups
9. Place one or two cups under the coffee outlet holes (12).
10. When the mains pilot light (1) turns green, turn the coffee extraction selector (2) to
the left until the selector mark points to the cup icon (fig.4). The coffee will start to
flow out.
11. Once the required amount of coffee has come out, turn the selector (2) back in the
opposite direction to the de-pressurisation position (fig. 5) to stop the coffee flow
and vent the residual pressure in the filter holder.
c. - Cleaning
- If you have used ground coffee, clean the grounds by placing the filter holder
under running water.
- If you used a single-dose pod, remove the bag and put it in the rubbish.
Steam:
To heat any type of liquid using the steam nozzle (9)
1. Plug the coffee maker into the mains and press the switch (1). The orange pilot
light will come on and change to green once the appliance is ready.
2. Next, press the steam switch (3) and wait until the pilot light comes on.
3. When the pilot light comes on, insert the steamer (9) into the liquid to be heated
and gradually open the steam nozzle control (8). Always handle the steam nozzle
(9) by the protective handle (10), to avoid potential burns.
4. After using, we recommend you clean any traces of dirt on the inside. To do this:
5. Place an empty container under the steam nozzle (9), turn on the steamer switch
(8) again and let the steam out.
6. Turn off the steam switch (3).
7. If you want to make coffee after using the steam nozzle, it is advisable to allow two
cups of water to run out through the filter holder (with no coffee in the filter) to
ensure that the next cup of coffee comes out at the right temperature.
The maximum steam draw-off time is about 1 min.

Cleaning and maintenance


Unplug the coffee maker from the mains.

Clean the tank and filter holder regularly.

Do not use alcohol, solvents or abrasive products to clean the coffee maker or
tray, just a soft damp cloth.

The appliance has an automatic de-pressurising system that channels some of the
water from the dregs into the tray. It is advisable to remove the water from the cup-
holder tray regularly.
- If you use the steam nozzle to heat milk, clean it as soon as possible for easy
cleaning. Wait for the steam nozzle to cool down and wipe it with a damp cloth.
- Every now and again, for more thorough cleaning of the steamer, proceed as
follows: wait until the steamer cools down and unscrew its cylindrical part
10