Rinsing At Switch-Off; Maintenance And Care; Changing The Filter - Rotel Adagio Mode D'emploi

The following settings are possible:
Rinsing at switch-off "OFF" = 1 bar
Rinsing at switch-off "ON" = 2 bars
• To access the basic settings menu hold the steam / rinsing button (5) more than
3 sec. until the symbol
• Press the steam / rinsing button (5) until the symbol
• Press the coffee button (4) until the desired number of bars are shown in the display.
• Press the steam / rinsing button (5).
• The bars blink three times to confirm.
☛
To end the programming and get back to coffee-ready-mode, hold the
steam / rinsing button (5) for more than 3 seconds.
☛
To continue with other programming, press the steam / rinsing button (5) brief-
ly and the next symbol appears.
4.6 Restoration of factory settings (Reset)
If you reset to factory settings, all of your programmed items will be reset. That means
that the settings will be the same as when you bought the machine.
• Press the steam / rinsing button (5) and the coffee button (4) simultaneously for
more than 3 sec.
• All bars blink three times to confirm.
• The factory settings have now been reset.

5. Maintenance and care

5.1 Changing the filter

The effectiveness of the filter will be exhausted after drawing approx. 50 liters of
water. The symbol appears on the display.
☛
You can still draw coffee, hot water and steam. We would, however, recom-
mend that you should always replace the filter immediately.
Please note:
If your use of water is lower, the filter must be replaced after two months at the latest.
No message appears in the display. You can set the replacement date using the spe-
cial rotary indicator on the top of the filter.
• To access the maintenance menu hold the aroma button (3) more than 3 seconds.
The symbol or
• If necessary turn the water dial (2) until the symbol appears.
• Empty the water tank (11).
28
13_1383_ROT_BA_AdaVero_IH.indd 28 13_1383_ROT_BA_AdaVero_IH.indd 28
lights up.
or appears.
appears.
06.01.14 10:23 06.01.14 10:23