C.padded Swing-Away Armrests; Height-Adjustable Armrests; Armrest Receiver Attachment - Quickie QRI Mode D'emploi

Q R I
C. PADDED SWING-AWAY ARMRESTS
Swing-away armrests can be detached or can swing away to allow lateral transfers.
They are height adjustable (2") by moving bolts (A) up or down in predrilled holes on
armrest bracket.
Swing-away, removable armrests are installed by sliding armrest into receiver (B) on back
frame.
Swing-away, angle adjustable
To change the angle, remove bolts (C), reposition to needed angle. Reinsert bolt and tighten.
D. HEIGHT-ADJUSTABLE ARMRESTS
1. Parts of the Armrest
1. Outer Armpost
2. Height Release Lever
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Receiver
8. Clamp
9. Receiver adjustment hardware
2. Installation
a. Slide the outer armpost into the receiver mounted to the wheelchair frame.
b. The armrest will automatically lock into place.
3. Height Adjustment
a. Rotate height release lever (2) to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad (4) until upper armpost locks firmly into place.
4. Removing Armrest
a. Rotate height release lever (2) to first stop and remove the armrest.
5. Replacing Armrest
a. Slide armrest back into receiver.
b. Return release lever (2) to locked position against armpost.
E. ARMREST RECEIVER ATTACHMENT
8 9
Mounting
1. Locate the two parts of the clamp receiver (A)(B) close to the center of the
frame tube.
8
2. Hold in place while hand-tightening the hardware (C) that will fasten the receiver in
place. 9
3. Insert the armpost into the receiver (B). Once inserted, Slide the receiver clamp and
armrest the optimum location. Before tightening the clamp hardware, make sure the
armrest is perpendicular to the rolling surface.
4. Tighten the clamp hardware (C) to secure the armrest and receiver assembly
(Optional)
6
(Optional)
5 6
7
.
9
17
X. SET-UP & ADJUSTMENT
5
A
B
6
C
4
6
2
1
8
9
8
B
A
C
9
B
A
C
7
5
3
7
122143 Rev. C