Sartorius Celsius S3 Mode D'emploi page 20

Les langues disponibles

Cryopilot Software

Operating Instructions Celsius

_Manual_Benchtop_Freeze_Thaw_System_S--6004-t210308_85034-538-54.indb 20

Cryopilot Software

5.1

Overview

The benchtop system is controlled and monitored by Cryopilot software,

which is a graphical application for computers with Microsoft Windows. The

Cryopilot software provides users with flexible execution of freeze and thaw

operations.

The following diagram illustrates the relationships between system

components. The Cryopilot software interfaces with the Cryopilot A chiller

and the Cryomixer Jr. shaker via USB, and with up to 16 thermocouples

through a National Instruments data acquisition device.

Fig. 13: Cryopilot System

5.2

System Requirements

Cryopilot software is factory-installed on computers ordered from Sartorius

as part of a benchtop system. Alternately it is available on USB flash drive for

systems that meet the following requirements:

— Operating System: Microsoft Windows 7 Professional, 32 bit with Service

Pack 1 or Microsoft Windows 10 Professional, 64 bit.

— Data Acquisition Device: National Instruments USB-9213.

Cryopilot software is packaged with an installer that will automatically install

the Cryopilot software and all required third-party drivers on your computer.

You must have administrative privileges to install Cryopilot.

Benchtop System

01.04.2022 09:52:15