Safety Warnings - Astralpool 41127 Manuel D'installation

7. TROUBLESHOOTING
PROBLEMS
The yellow LED in the DMX modulator
does not light up
The green LED in the DMX modulator
does not light up
The projectors do not respond to the
orders from the DMX controller or the
colours do not coincide with those
required
The projectors change colour or go out
for a few moments
If you are unable to solve the problem with these instructions, contact the technical department of AstralPool.

8. SAFETY WARNINGS:

• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING POOLS
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components which
have been inserted or handled at locations other than its own premises.
USUAL CAUSES
Current is not reaching the equipment
Faulty DMX signal
Incorrect configuration of the modulator
switch
Faulty power supply in the projectors or
in the DMX modulator
6
SOLUTIONS
Check the mains socket (230 Vac) and
the 12 Vac power line
Check the installation of the DMX line.
Only the line termination of the last
DMX equipment of
communications bus
activated (2-position DIP switch)
Check that the channels assigned to the
modulator (9-position DIP
correspond to those enabled in the DMX
controller
Check the 12Vac power supply line of
the projectors and the DMX modulator
the DMX
should be
switch)