Fading In And Out (Fader); Playing An Md Using A Timer - Sony MDS-JE520 Mode D'emploi

Playing MDs

Fading In and Out (Fader)

You can gradually increase the playback level of the
signal output to the LINE (ANALOG ) OUT jacks and
the PHONES jack at the beginning of a playback (fade-
in playback) or gradually decrease the playback level
at the end of a playback (fade-out playback).
This function is convenient when, for example, you
want to start or end playback in the middle of the
track.
FADER
Fade-in playback
During playback pause, press FADER at the position
where you want fade-in playback to start.
Z in "Fade Z 3.2s" flashes and the deck performs fade-
in playback until the counter reaches to "0.0s".
Fade-out playback
During playback, press FADER at the position where
you want fade-out playback to start.
z in "Fade z 3.2s" flashes and the deck performs fade-
out playback until the counter reaches "0.0s".
The deck changes to playback pause when fade-out
playback finishes.
Note
The signal level output to the DIGITAL OUT connector does
not change.
z
You can set the duration of fade-in and fade-out
playback independently
Do Steps 1 to 5 in "You can set the duration of the fade-
in and fade-out recording independently" on page 17.
26 EN
21 22 23 24 25
Z – . ,
REPEAT A˜B A.SPACE M.SCAN
/ > 25 ? ! ( )
WRITE CLEAR
NAME CHAR NUM
· P p
= + r
T.REC MUSIC SYNC
0 )
CD-SYNC
STOP START STANDBY
CD PLAYER FADER
P = +
FADER
LEVEL

Playing an MD Using a Timer

By connecting a timer (not supplied) to the deck, you
can start and stop playback operations at specified
times. For further information on connecting the timer
or setting the starting and ending times, refer to the
instructions that came with the timer.
TIMER PLAY MODE
1
Do Steps 1 to 3 in "Playing an MD" on page 8.
2
Press PLAY MODE repeatedly (or one of the
PLAY MODE buttons once) to select the play
mode you want.
To play only specific tracks, create a program (see
page 23).
3
• If you want to specify the time for the start of
playback, go to Step 4.
• If you want to specify the time for the end of
playback, press · to start playback, then go to
Step 4.
• If you want to specify the time for both start and
end of playback, go to Step 4.
4
Set TIMER on the deck to PLAY.
5
Set the timer as required.
• When you have set the time for the start of
playback, the deck turns off. When the specified
time arrives, the deck turns on and starts
playing.
• When you have set the time for the end of
playback, playback continues. When the
specified time arrives, the deck stops playing
and turns off.
• When you have set the time for both the start
and end of playback, the deck turns off. When
the starting time arrives, the deck turns on and
starts playing. When the ending time arrives,
the deck stops playing and turns off.
6
After you have finished using the timer, set
TIMER on the deck to OFF.
§
EJECT
≠ ±
AMS
0 ) r
·
P p
·