Sony MDS-JE520 Mode D'emploi page 34

Editing Recorded MDs
6
Press LEVEL/DISPLAY/CHAR to select the
character type as follows:
To select
Uppercase letters
Lowercase letters
Numbers
7
Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! " # $ % & ' ( ) * + , – . / : ; < = > ? @ _ `
You can press LEVEL/DISPLAY/CHAR to change
the character type at any time during Step 7 (see
Step 6).
8
Press AMS to enter the selected character.
The cursor shifts rightward and waits for the input
of the next character.
34 EN
Press LEVEL/DISPLAY/CHAR
repeatedly until
"A" appears in the display
"a" appears in the display
"0" appears in the display
9
Repeat Steps 7 and 8 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
To erase a character
Press 0 or ) until the character to be erased
starts flashing, then press CLEAR.
To enter a space
Press AMS while the cursor is flashing.
10
Press YES.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press MENU/NO or p.
Note
You cannot label a track or an MD while you are recording
over an existing track.