Recording Over Existing Tracks - Sony MDS-JE520 Mode D'emploi

Notes
• When you turn off the Smart Space Function, the Auto Cut
Function is also turned off automatically.
• The Smart Space Function and Auto Cut Function are
factory set to on.
• If you turn off the deck or disconnect the AC power cord,
the deck will recall the last setting (On or Off) of the Smart
Space and Auto Cut Functions the next time you turn on
the deck.
Playing back tracks just recorded
Do this procedure to immediately play back tracks that
have just been recorded.
Press · immediately after stopping recording.
Playback starts from the first track of the material just
recorded.
To play from the first track of the MD after
recording
1 Press p again after stopping recording.
2 Press ·.
Playback starts from the first track of the MD.
Recording on MDs

Recording Over Existing Tracks

Follow the procedure below to record over existing
material just as you would on an analog cassette tape.
≠ AMS ±
§
EJECT
≠ ±
AMS
0 )
r
·
P p
1
Do Steps 1 to 5 in "Recording on an MD" on
page 6.
2
Turn AMS (or press = or +) until the
number of the track to be recorded over appears.
3
To record from the start of the track, continue
from Step 6 in "Recording on an MD" on page 7.
z
While "Tr" flashes in the display
The deck is recording over an existing track, and stops
flashing when it reaches the end of the recorded
portion.
z
To record from the middle of the track
1 After Step 2 above, press · to start playback.
2 Press P where you want to start recording.
3 Continue from Step 6 in "Recording on an MD" on
page 7.
Note
You cannot record from the middle of an existing track when
the "PROGRAM" or "SHUFFLE" is on.
WRITE CLEAR
NAME CHAR NUM
·
P p
=/+
= + r
T.REC MUSIC SYNC
0 )
CD-SYNC
STOP START STANDBY
CD PLAYER FADER
P = +
LEVEL
11 EN