Marking Track Numbers While Recording (Track Marking) - Sony MDS-JE520 Mode D'emploi

Adjusting the analog recording level
1
Do Steps 1 to 6 in "Recording on an MD" on
pages 6 and 7.
Set INPUT to ANALOG in Step 4.
2
Play the portion of the program source with the
strongest signal level.
3
Press LEVEL/DISPLAY/CHAR (or DISPLAY)
repeatedly until the recording level adjustment
display appears.
4
While monitoring the sound, turn AMS (or press
LEVEL +/– repeatedly) to adjust the recording
level.
The volume can only be increased up to +12.0 dB.
Therefore, if the output level of the connected
component is low, it may not be possible to set the
recording level to maximum.
5
Stop playing the program source.
6
To start recording, do the procedure starting from
Step 8 in "Recording on an MD" on page 7.
z
You can use Setup Menu 10 to adjust the analog
recording level
1 While recording or in recording pause, press MENU/
NO twice to display "Setup Menu".
2 Turn AMS to select "Setup 10", then press AMS.
3 Turn AMS to adjust the recording level, then press
AMS.
4 Press MENU/NO.
Recording on MDs
Marking Track Numbers While
Recording (Track Marking)
You can mark track numbers either manually or
automatically. By marking track numbers at specific
points, you can quickly locate the points later using the
AMS Function, or use various Editing Functions.
Marking track numbers manually
(Manual Track Marking)
You can mark track numbers at any time while
recording on an MD.
Press r REC at the place you want to add a track mark
while recording.
Marking track numbers automatically
(Automatic Track Marking)
The deck adds track marks differently in the following
cases:
• When recording from CDs or MDs with the INPUT
switch set at OPT 1 or OPT 2:
The deck marks track numbers automatically.
However, the Automatic Track Marking Function
does not activate when recording from some CD
players and multi disc players.
• In all other cases:
If "T.Mark LSyn" is selected in Setup Menu 02, the
deck marks a new track number whenever the signal
drops to the specified level or below for about
1.5 seconds or longer, then rises to a specified level.
r REC
MENU/NO
§
EJECT
≠ ±
AMS
0 ) r
·
P p
≠ AMS ±
(Continued)
13 EN