Fading In And Fading Out - Sony MDS-JA333ES Mode D'emploi

1
While the deck is playing, press MENU/NO twice.
"Setup Menu" appears in the display.
2 Turn AMS (or press ./> repeatedly) until
"Pfine" appears, then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) until the
desired value appears, then press AMS or YES.
4
Press MENU/NO.
To recall the factory setting
Press CLEAR while setting the value.
Notes
• The playing sound drops out momentarily when you change
the fine control value.
• The fine control value reverts to "0.0%" (factory setting) when
you turn off the deck or eject the MD.
• The step and fine control values are linked; changing one value
also changes the other.
40
GB
Changing the pitch/Fading in and fading out

Fading in and fading out

You can use Fade-in Play to gradually increase the signal
level to the ANALOG OUT jacks and the PHONES jack
at the start of playing. Fade-out Play gradually decreases
the signal level at the end of playing.
Fade-in Recording gradually increases the signal level at
the start of recording. Fade-out Recording gradually
decreases the signal level at the end of recording.
Z
H X
. >
m M
X . >
Note
The level of the signal output from the DIGITAL OUT connector
does not change during Fade-in Play nor Fade-out Play.
Fade-in Play and Fade-in Recording
During play pause (for Fade-in Play) or recording
pause (for Fade-in Recording), press FADER.
b flashes in the display and the deck performs Fade-in
Play or Fade-in Recording for five seconds (factory
setting) until the counter reaches "0.0s."
Fade-out Play and Fade-out Recording
During play (for Fade-out Play) or recording (for Fade-
out Recording), press FADER.
B flashes in the display and the deck performs Fade-out
Play or Fade-out Recording for five seconds (factory
setting) until the counter reaches "0.0s," then pauses.
Z
` / 1
x
FADER