Sony MDS-JA333ES Mode D'emploi page 13

3 Turn AMS (or press ./> repeatedly) to change
the setting, then press AMS.
4 To complete the setting, press AMS or m/M
repeatedly until the minute indication flashes, then
press AMS or YES.
Displaying the current date and time
You can display the current date and time any time while
the power is on.
Press DATE PRESENT.
Each press of the button changes the display as follows:
Current display
r
Date
r
Time
z
For precise date and time stamping of recordings
Reset the time at least once a week.
Note
If the AC power cord is disconnected for a long time, the
memorized clock settings will disappear and "Initialize" will
flash in the display the next time you plug in and turn on the
deck. If this happens, reset the clock.
Displaying the recorded date
You can then check the recorded date and time of a track.
Press ./> or number buttons to locate the
1
track you want to check.
2
Press DATE RECORDED.
"No Date" appears if the internal clock has not been
set or the track was recorded to another MD deck
without a date and time stamp function.
Z
Z
13
GB
Setting the clock