Parkside Performance PABSP 20 Li C3 Instructions D'utilisation Et Consignes De Sécurité page 51

m IMPORTANT!
During the firmware update the connection
u
status LED flashes 5× per second. Do
[ ]
not disconnect the smart battery pack
from the cordless drill during the update
as the cordless drill will become unusable
if the update fails. During the update the
cordless drill becomes unresponsive to
input, e.g. triggering the on/off switch. The
update process takes around 5 minutes.
If the firmware update is successful, the
connection status LED flashes 1× per
second for 5 seconds. The cordless drill
becomes responsive to input again. You
can connect the battery pack to the
Lidl Home app following the chapter
"Connecting the product to the Lidl Home
app".
˜ Reconnecting the cordless drill
m IMPORTANT!
If the connection status LED
u
alternatively between 1× and 5×
per second, it means the connection
was disrupted. One of the reasons is
disconnecting the battery pack from the
cordless drill during firmware update. The
cordless drill will not be usable until you
re-established the connection it.
Proceed as follows to re-establish the connection
with the cordless drill:
1. Attach the battery pack to the cordless drill.
2. Press the on/off switch
status LED flashes alternatively 1× or 5×
[ ]
per second.
3. Enable Bluetooth on your mobile product.
4. Press and hold the
level) on the smart battery pack for 3 seconds
to ensure that Bluetooth is activated on the
battery pack.
flashes
[ ]
. The connection
6 ] [
button (charging
5. Connect the battery pack to the Lidl Home
app following the chapter "Connecting the
product to the Lidl Home app".
{Device info}
6. Select
under {Battery}. The overview page of the
cordless drill is displayed.
{Firmware
7. Select
firmware.
8. After successfully updating the firmware, the
connection with the cordless drill should be
re-established and the cordless ready for use.
˜ Reset to factory original
setting
{Reset}
Select to restore the firmware to
o
original factory setting.
˜ Privacy policy
You can find the complete data protection
guideline under the tab
protection}{guideline}.
˜ Disconnecting the product and
deleting data from the app
1. In the tab, select the product that you
want to remove and whose data you want to
delete.
2. Select the icon in the top right.
{Remove device}.
3. Select
4. To delete the data, select
delete data}. If you just want to disconnect
the product without deleting the data, select
{Disconnect}.
˜ Problems with the app ‒ FAQ
1. Select the battery pack you have questions
about from the product list.
2. Select the icon in the top right.
{Other}
3. Under select the option
(= frequently asked questions).
"PABSP 20 Li C3"
version}
and update the
{Data
{Disconnect and
{FAQ}
GB/IE 49