Setting The Rotating Direction; Torque Control; Switching On And Off; Speed Control - Parkside Performance Pabsp 20 Li C3 Instructions D'utilisation Et Consignes De Sécurité

˜ Setting the rotating direction
m ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the rotation direction
switch until the product has come to
[ 5 ]
a standstill.
Change the direction of rotation by pressing
o
the rotation direction switch towards the left or
right (fig. G).
When the rotation direction switch is in the
o
middle position, the on/off switch
locked.
˜ Torque control
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded.
The torque can be adjusted by turning the
o
torque sleeve (fig. H).
[ 3 ]
Small screws or soft materials: Select a low
o
level.
Large screws, hard materials or removing
o
screws: Select a high level.
For drilling operation: Turn the torque sleeve
o
to the position.
˜ Switching on and off
NOTE
The on/off switch
6 ] [
Switching on: Press and hold the on/off
o
switch.
Regulate the speed as required (see "Speed
control") (fig. I).
Switching off: Release the on/off switch.
o
˜ Speed control
By using the on/off switch
o
progressively control the speed:
44 GB/IE
is
6 ] [
cannot be locked.
, you can
6 ] [
Pressure
Gentle pressure
Greater pressure
˜ LED work light
This product is equipped with a LED work light
to illuminate the immediate working area to
improve visibility in poorly lit areas.
The LED work light lights up automatically as
o
soon as the product is switched on.
NOTE
The LED work light stays on for an
u
additional approx. 10 seconds after
switching off the product.
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement. Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises.
Before operating the product, check whether
o
the accessory tool is correctly positioned, i.e.
centred in the chuck
Screw bits are labelled according to their
o
dimensions and their shape. If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free
play.
˜ Working instructions
Torque
Smaller screws/bits can be damaged if you
o
set the torque or rotational speed too high.
Speed
Lower speed
Higher speed
[
.
1 ] [
]