Cleaning The Roller On The Allteq Floorhead; Cleaning And Care - Miele HS16 Mode D'emploi

en
 Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 29)
(depending on model)
Clean the roller on the floorhead if re-
quired.
 Release the bearing (with bayonet fit-
ting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.

Cleaning and care


Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.
Follow the special cleaning instruc-
tions for the dust container and filter
frame in "Maintenance" and for the
fine dust filter, the pre-filter and the
fine dust container in "Fault resolu-
tion".
40

Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents.

Do not let the vacuum cleaner
get wet. If moisture gets into the va-
cuum cleaner, there is a risk of elec-
tric shock.