Use - Miele HS16 Mode D'emploi

en
The crevice nozzle and the upholstery
nozzle are located in holders at the rear
of the vacuum cleaner.

Use

Adjusting the telescopic suction tube
(dia. 07)
One part of the telescopic suction tube
is packed inside the other, and it can be
adjusted to suit your height for comfort-
able vacuuming.
 Press the release button and adjust
the tube to the desired height.
Using the Electrobrush
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
The Electrobrush is particularly suitable
for intensive vacuuming of carpets
which are subject to hard wear.

The Electrobrush should not be
used for vacuuming deep-pile rugs
and carpets or valuable hand-knot-
ted rugs and carpets, e.g. Persian
and oriental rugs etc. There is a
danger of the threads being pulled
out.
For further information on use and
maintenance please refer to the separ-
ate instructions supplied with the Elec-
trobrush.
Using the adjustable floorhead
Please observe the flooring manu-
facturer's cleaning and care instruc-
tions.
36
This floorhead can be used for all nor-
mal cleaning of carpets and rugs. It is
also particularly suitable for vacuuming
hard flooring which is not susceptible to
scratching.
Adjusting the floorhead (dia. 08 + 09)
Clean hard flooring which is not sus-
ceptible to scratching, as well as floor-
ing with gaps or deep crevices in it with
the brush protruding:
 Press the  foot control.
This type of flooring can be briefly va-
cuumed with the brush retracted. Car-
pets and rugs should be vacuumed with
the brush retracted:
 Press the  foot control.
Adjustable floorhead (dia. 10)
The adjustable floorhead can also be
used for vacuuming the stairs.

For safety reasons when vacu-
uming stairs, it is best to start at the
bottom of the stairs and move up-
wards.
Unwinding the mains cable (dia. 11)
 Pull the mains cable out to the re-
quired length.
 Insert the plug into the socket.

If vacuuming for longer than 30
minutes, the cable must be pulled
out all the way. There is a risk of
overheating and damage.
Rewinding the cable (dia. 12)
 Switch off at the wall socket and un-
plug it.