Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.8 Remote control
Place the remote control receiver in the bottom left corner of the unit before mounting the decorative
frame.
Slide the cable between the outer casing
and the bottom plate of the combustion
chamber.
2.9 Operating instructions for the remote control
2.9.1Setting the display (from F/12h to C/24h, and vice versa)
After fitting the battery (9V alkaline) or pressing the buttons AUTO and
TIMER at the same time, the display will start blinking. As long as the
display is blinking, you can switch from F to C by pressing the AUTO
button. After some time, the display will return to manual operation. You
can also press the TIMER button.
2.9.2 Setting the time
After fitting the battery or pressing the AUTO and TIMER buttons
simultaneously, the display will start blinking. To set the time, press the
() button to set the hours, and press the () button to set the minutes,
or press the TIMER button to return to manual operation.
2.9.3 Setting the desired temperature
Press the AUTO button until the 'temp' indication starts to blink. Then
press the () or the () button to set a higher or lower temperature. Then
wait, or press the AUTO button to get to the automatic mode.
The sensor in the remote control measures the temperature in the room;
the temperature is compared with the pre-set temperature, then the
receiver on the stove gets a signal and adjust the height of the flames to
the temperature in the room.
2.9.4 Programming the timer function
Keep the TIMER button pressed until the indication P1 blinks.
Then program the switch-on time with the () button for the hours, and the
() button for the minutes; then press TIMER again until P1 appears to
program the switch-off time. By pressing TIMER again you can preset the times for the second program
P2 P2 and confirm it with pressing TIMER. The symbol will appear outside programmed times.
17
Publicité
Chapitres
Table des Matières
