Installation; Operation (Remote Control) - WANDERS Kanda Gas Mode D'emploi Et Instructions D'installation

Installation

It is common practice for the dealer where you pur-
chased your gas unit to take also care of installing it
and connecting it to the mains. If this is not the case,
please ensure that the installation is done by a certified
installer. Connecting gas devices by unqualified persons
is prohibited, in which case we cannot give any guaran-
tee that your gas hearth is functioning properly.
Ready for use
First insert the batteries (see page 20).
Once the batteries are inserted, the electronic code must
be set (only when used for the first time). Press the reset
button on the receiver and release the reset button after
within 20 seconds until hearing a long signal indicating
that the code is set.
Setting the time
to indicate that you are now in the set mode.
to set the minutes.
OFF
manual mode.
Switching from ºC/24 hours to ºF/12 hours
(2 sec) to switch from ºF (and the 12
hour clock) to ºC (and the 24 hour clock) and vice
18
and
button to return to the
OFF button and the small
versa.
Optional settings
SET
switch from MAN day temperature
ture timer man.
MAN
Day temperature ( ): this mode allows you to set
the desired daytime temperature; the remote control
functions as the thermostat.
Night temperature ( ): this mode allows you to set
the desired night temperature.
TIMER: the timer mode allows you to set two burner
ON times and two burner OFF times per 24 hours. If
the night setting indicates - - - the stove will burn at
Setting the temperature
SET button
SET button
minimum day temperature).
OFF button
stat-controlled operation.
perature for the night until you see the - - - symbol in
the display.
Setting the timer function
button a couple of times.
SET button
(
SET button
to end the setting.

Operation (remote control)

Lighting the fire
pipe leading to the appliance.
O I" switch
I" position.
on the gas control block to the
ON position.
A short audible signal indicates the start after which
short sound signals (a 1Hz sound of 0.2 sec) can be
full load.
button you can quickly
night tempera-
.
.
for a longer time until
or (5 ºC is the
to return to thermo-
-
SET
for a longer time until P1
, the minutes with .
for the next timing.
OFF button
on the gas control block
and on the handset.