WANDERS Kanda Gas Mode D'emploi Et Instructions D'installation page 24

Gastype A (min.-max.)
Nat. gas 1,0 - 3,0 m
Nat. gas 1,2 - 3,0 m
all lengths are exclusive the wall outlet
Roofoutlet
essary with a bend to the ridge of the roof. The roof duct
is supplied with a universally adjustable roof tile for a
Ø 155 mm for the roof duct.
pliance. Push them firmly together and place the clip
bindings.
sure that the transfer tile or the universal roof tile is
well fitted to the roof.
concentric pipes to the roof duct.
24
B (min. - max.) pipe closer
0 - 0,5 m NO
1,0 - 3,0 m NO
-
-
-
Gastype A (min. - max.)
Nat. gas 5,0 - 10,0 m
Nat. gas 1,0 - 5,0 m
all lengths are exclusive the roof outlet
Gastype B (min. - A1 (min. -
max.) max.)
Nat. gas 1 - 3 m 1 - 10 m
(A1 + A2 : B) : 1 Proportion vertical : horizontal (or 45
up) is always at least 2 : 1
all lengths are exclusive the roof outlet
First install the pipe system, and then place the gas
unit
You may also fit the concentric pipe system before plac-
ing the gas unit, but then you must the connection to the
gas unit with a pipe that can be shifted.
Important
built chimneybreast made of incombustible material.
the gas stove, you must place fire-resistant plates.
grid on the upper side and underside (see illustration
on page 24). The minimum distance from the appli-
ance to the back wall is 10 cm. The minimum dis-
tance on the left or right side of the stove is 10 cm.
Warm air
Cold air
pipe closer
Ø 50 mm
Ø 65 mm
A1 + A2 pipe
(min. - max.) closer
1 - 10 m NO
o
Warm air
Cold air