Operation (Manual) - WANDERS Kanda Gas Mode D'emploi Et Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Possible error messages:
ing ignition
indicate that the batteries of the re-
ceiver are almost exhausted. (The appliance can still
be switched on for another 10 times after hearing this
signal.)
may indicate that one of the cables is not connected
O I
burner has failed. Possible reason is air in the pilot-
Important: If the pilot flame has extinguished you must
wait at least 5 MINUTES before repeating the above ac-
tions.
Setting the height of the flames
tomatically be in the highest position.
and to extinguish the burner (extinguishing the fire:
STAND BY
pressing button
Switching off the appliance
off the appliance.
OFF" button
advisable to close the gas tap in the gas supply pipe.
Important: If for whatever reason the pilot flame has ex-
tinguished you must wait 5 MINUTES before lighting the
pilot again.
Malfunctioning
If it appears that the signals of the remote control are not
(properly) picked up by the stove (receiver), this may be
caused by:
-
is an error message. It
I" position.
-
will gradu-
to switch off the whole
RESET" button on the receiver.
to contact your installer.

Operation (manual)

If the batteries are dead or if the receiver is defect, the
stove can also be manually operated. First disengage the
ignition cable (piezo) cable from the receiver and care-
fully slide it onto the piezo connection of the gas control
block.
Ignition of the fire
1.
Open the gas shut-off cock, which is fitted on the
gas pipe to the appliance.
O I" switch
on the gas control block in the
I" position.
3.
Turn motor switch
on the gas control block com-
pletely to the right; the switch will make a ticking
sound.
4.
Turn control switch
the MAN position; an opening in the control switch
will become visible
5.
Press the metal pin in the opening, with a pointed
lot.
switch
while keeping the pressure on the metal pin. Check
ing.
7.
Once the pilot is burning, keep the metal pin
pressed for another 10 seconds, and then release
on the gas control block to
.
O I" switch) several times
-
-
19

Publicité

Table des Matières
loading

Table des Matières